INVESTIGATION OF FEEDING ROLLERS ALIGNMENT  IN A HORIZONTAL PLANE

Ol'ga Tarasova; Mariia Chernova

doi:10.5937/jaes15-12449

Ol'ga Tarasova Volga State University of Technology, Yoshkar-Ola
Mariia Chernova Volga State University of Technology, Yoshkar-Ola

DOI: https://doi.org/10.5937/jaes15-12449

Keywords: setting inaccuracy, feeding rollers, axes alignment, arrangement accuracy,

Abstract

This research represents the ways of estimation of woodworking machines’ feed rollers arrangement in a horizontal plane as exemplified by control of the position of the feed rollers axes on a frame saw. Some significant considerations have been stated in relation to standard methods of control GOST 10294, which contain accuracy value and monitoring techniques. Some methods are recommended in the following research, which allow monitoring value of possible deviations of mutual arrangement of feed rollers in a horizontal plane. This is done with due consideration of inaccuracy of their setting, as well as radial beats that results from exploitation, by means of conducting measurements in two mutually perpendicular planes.

References

Eklund, (2000), U Influencing factors in sawing accuraly in a bandsawill, Holz Roh – und Werkst.

GOST 2140-81 visible defects, of wood. Classification, terms and definitions, methods of measurement (1981), Mosсow, 118р. GOST 5524 – 75 Saws for vertical gang mills, (1975), Mosсow, 10р.

GOST 10294 – 90. Woodworking equipment, Vertical two-storey saw frames. Basic parameters. Standards of accuracy (1990), 9р.

GOST 20911 – 89. Technical diagnostics. Terms and definitions, (1989), Mosсow, 9р.

GOST 25338 – 82. Woodworking equipment. Accuracy and rigidity test. General requirements, (1991), Moscow, 7р.

Tarasova O. G. Issledovanie i sovershenstvovanie standartnyh sposobov kontrolja i povyshenija kachestva piloprodukcii: dis.... kand. tehn, nauk. – М. 2011. – 259 p.

Pat. 2538480 Rossijskaja Federacija MPK V27B 27/00 G01C 9/24 Sposob dlja ocenki gorizontal’nosti ploskih i cilindricheskih poverhnostej / Bojarskij M.V., Tarasova O.G. No2012153655/13; Bojarskij M.JuV., zajavl. 11.12.2012; 10.01.2015 Bjul. No 1.

RPI 6.1-00, Rukovodjashhie tehnicheskie materialy po opredeleniju rezhimov pilenija na lesopil’nyh ramah (1987), Arhangel’sk: CNIIMOD.

Tarasova, O.G., S.V. Shlychkov, (2016), Vlijanie defektov tehnicheskoj sistemy na parametry proizvodimyh pilomaterialov, Remont, vosstanovlenie, modernizacija. No 1, p. 13–17.

Tehnologicheskie rezhimy RPI 6.1-00. Podgotovka ramnyh pil (1982), Arhangel’sk, CNI-IMOD.

Vuorilehto, Jaakko. (2002) Quelity yield capability of a breakdown sawing process, Jaakko Vuorilehto, Forest Prod. J, 52No4, Р. 77-81.