Study on a new process and its kinetics of iron recovery and glass-ceramics preparation from desulfurization slag
Abstract
This paper creatively proposes a new process with desulfurization slag leached by ammonium chloride as pretreatment, and the main point of this paper lies in the processing of desulfurization residue leached by ammonium chloride. Through component analysis the formula is adjusted with high aluminum coal ash and glass cullet, making the melting point of the reduction slag around 1200 ℃, which facilitates the separation of iron and slag At the same time, the reduction slag is adjusted to the target crystallization phase, so that the high temperature reduction slag after carbon thermal reduction can be used to produce glass-ceramics directly. The results show that iron recovery rate is over 99%, and diopside and nepheline glass-ceramics are produced, which shows that the new process is feasible. However, the crystal growth index is less than 3, which means that the crystallization capacity of the glass-ceramics is low, and nucleating agent is needed in the preparation of glass-ceramics.
Authors retain copyright of the published papers and grant to the publisher the non-exclusive right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media.
The Author(s) warrant that their manuscript is their original work that has not been published before; that it is not under consideration for publication elsewhere; and that its publication has been approved by all co-authors, if any, as well as tacitly or explicitly by the responsible authorities at the institution where the work was carried out. The Author(s) affirm that the article contains no unfounded or unlawful statements and does not violate the rights of others. The author(s) also affirm that they hold no conflict of interest that may affect the integrity of the Manuscript and the validity of the findings presented in it. The Corresponding author, as the signing author, warrants that he/she has full power to make this grant on behalf of the Author(s). Any software contained in the Supplemental Materials is free from viruses, contaminants or worms.The published articles will be distributed under the Creative Commons Attribution ShareAlike 4.0 International license (CC BY-SA).
Authors are permitted to deposit publisher's version (PDF) of their work in an institutional repository, subject-based repository, author's personal website (including social networking sites, such as ResearchGate, Academia.edu, etc.), and/or departmental website at any time after publication.
Upon receiving the proofs, the Author(s) agree to promptly check the proofs carefully, correct any typographical errors, and authorize the publication of the corrected proofs.
The Corresponding author agrees to inform his/her co-authors, of any of the above terms.